Photovoltaic Cell Prepared from Nanoparticles of CdS/CdTe on ITO Substrate and its Characterization

Abstract

CdS/CdTe based photovoltaic cell has shown the markable efficiency. The CdS/CdTe nanoparticles are being synthesized and deposited on the ITO glass plate. ITO glass has a large bandgap of about approximately 3.6 eV and is suitable to use in the fabrication of photovoltaic cell. As ITO behaves as negative terminal, it is used as front layer for capturing the light intensity. During fabrication of photovoltaic cell, the deposition of Cadmium sulphide and Cadmium telluride nanoparticles layer was done by brush painting technique. The CdS layer is used as window layer and CdTe acts as absorbing layer. The window layer’s primary function is to absorb light particularly in the visible region of the spectrum to generate electricity. The CdS layer forms p-n junction with the CdTe layer. The nanoparticles of CdS and CdTe have been synthesized first and optical characterization was carried out using UV-visible spectroscopy to obtain bandgap of CdTe and CdS. Structural characterization was being obtained by XRD. The size of the nanocrystallites of CdS and CdTe have been obtained by Debye Scherrer equation and the result was 1.64 nm and 4.09 nm respectively. The CdTe layer which was used as absorbing layer consists of high optical absorption coefficient with high mobility, good carrier lifetime and an enhanced properties of crystallographic. Silver paste was used as a back contact for good conduction.